All FAQs (1757 total: showing 761-780)
- What are the calibration procedures for the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH, and how are they traceable to the National Institute of Standards and Technology (NIST)?
- Is the crosswind correction applied to the raw data of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
- Are there any corrections to the raw data (not the average data) obtained by the CSAT3/3A/3AH?
- Can the CSAT3/3A/3AH give a time stamp with each measurement value?
- What is the direction definition of vertical wind speed for a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH? For example, does a negative value mean upward or downward?
- What should be done if the CSAT3/3A/3AH cannot be found in the Short Cut list of sensors?
- Are there any data logger programming changes that must be made to a program when using a long Synchronous Device for Measurement (SDM) cable with a CSAT3?
- Can a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used to measure wind flow angle, horizontal angle, and wind speed for the purpose of power curve testing?
- If the polymer coating at the ends of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH transducers starts coming off, is that a problem?
- What is the absolute accuracy of the speed of sound measurement in the CSAT3/3A/3AH?
- Are there any mounting options for the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH that lend themselves to frequent repositioning?
- If the temperature drops below -30°C, is that a problem for a CSAT3A or CSAT3B?
- Is the CSAT3/3A/3AH only compatible with Campbell Scientific data loggers?
- Is the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer measurement limited by precipitation?
- Can the bubble level on the CSAT3/3A/3H be replaced?
- Can the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used in low-speed conditions, such as less than 5 cm/s? If so, what are the resolution and accuracy at these low speeds?
- What are the mounting options for the CSAT3?
- Is the offset relatively constant for a single CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
- How often does a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer need to be recalibrated?
- Is there a way to determine the time at which the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH started reporting data with sub-second precision?
Previous
Next