FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1757 total: showing 401-420)

Can the SR50A-L be used in small-diameter wells?
Can an SR50A-L be connected to a data logger on an SDI-12 port?
Does the SR50A-L need a temperature probe?
To use the CPEC200/310 scrub module as a source of zero gas, is it necessary for the CPEC200/310 system to include a valve module?
Is there a calibration procedure for the PWS100?
At a consistently windy site, is a PWS100 less accurate than a tipping bucket rain gage?
How can a copy of the PWS100 Present Weather Viewing Software be obtained?
What does the Present Weather Viewing Software do? For example, can it save data?
Can a PWS100 be used to measure visibility? If so, can it be used in a sandy area such as the Sahara Desert?
What is the current drain of the PWS100?
How is the PWS100 different from a rain gage or snow depth sensor?
Can an HFP01SC provide correct running averages if the scan rate is reduced to 1 minute?
If Short Cut does not list the TCAV on its sensor list, what should be done?
Is it OK to have a TCAV connected to a data logger using a very long cable (100 ft/30 m)?
What are the measuring range, accuracy, and resolution of the TCAV?
What might cause a 25% difference between the factory calibration and the in-situ calibration of an HFP01SC?
What type of quality assurance/quality control can be performed on HFP01SC measurements?
For the HFP01SC, is there an available acquisition program that is capable of running in PipeLineMode?
If Short Cut does not list a heat flux plate on its sensor list, what should be done?
Does the HFP01SC have to be in direct thermal contact with the surrounding soil to achieve heat flux readings?

Previous Next